• Masoumeh Lotfinezhad 1

  • Maryam Tahmasebpoor 2

  1. 1 Department of Chemical & Petroleum Engineering, Faculty of Chemical & Petroleum Engineering, University of Tabriz, Tabriz, Iran
  2. 2 Department of Chemical Engineering, Faculty of Chemical and Petroleum engineering, University of Tabriz, Tabriz, Iran

Abstract

This study examined and compared the adsorption behavior and fluidity of two common adsorbents: activated carbon made from jujube seeds and titanium oxyhydroxide (TiO(OH)2) used in carbon dioxide capture. The activated carbon was produced through chemical activation with potassium hydroxide as the activating agent at a 2:1 weight ratio to the biomass. To assess the characteristics of the adsorbents, techniques such as SEM, BET, FTIR, and TGA were employed. The carbon dioxide adsorption capacity was tested at 25 and 50 °C. Regeneration was performed at 120 °C with a gas flow rate of 50 cm³/min. Adsorption was conducted for 1 hour, and desorption for 30 minutes, using 10% and 90% carbon dioxide concentrations in equilibrium with nitrogen. Results indicated that activated carbon had a significantly higher carbon dioxide adsorption capacity than TiO(OH)2 under the same conditions. To evaluate the fluidity of the different adsorbents, a gas-solid fluidized bed apparatus was used. Adding 5% by weight of hydrophobic silica nanoparticles to the adsorbents improved fluidity and increased bed expansion, due to reduced cohesive interactions between particles. The comparison of results highlights the considerable effectiveness of activated carbon as an efficient adsorbent for carbon dioxide capture.

Keywords

Subjects

 Air pollution

Asgharizadeh, K., Tahmasebpoor, M., Azimi, B., & Imani, M. (2024). Fluidity comparison of biomass-derived activated carbon and TiO (OH)2 and its improving toward promoted low-temperature CO2 capture in gaseous medium. Chemical Engineering Research and Design, 202, 23-37. DOI: https://doi.org/10.1016/j.cherd.2023.12.019.
Athari, M.-J., Tahmasebpoor, M., Azimi, B., Heidari, M., & Pevida, C. (2023). Waste oleaster seed-derived activated carbon mixed with coarse particles of fluid catalytic cracking as a highly-efficient CO2 adsorbent at low temperatures. Process  Safety and Environmental Protection, 178, 580-594. DOI: https://doi.org/10.1016/j.psep.2023.08.062.
Azimi, B., Tahmasebpoor, M., Sanchez-Jimenez, P. E., Perejon, A., & Valverde, J. M. (2019). Multicycle CO2 capture activity and fluidizability of Al-based synthesized CaO sorbents. Chemical Engineering Journal, 358, 679-690. DOI: https://doi.org/10.1016/j.cej.2018.10.061.
de Salazar Martínez, E. M., Alexandre-Franco, M. F., Nieto-Sánchez, A. J., & Cuerda-Correa, E. M. (2024). Exploring the role of surface and porosity in CO2 capture by CaO-based adsorbents through response surface methodology (RSM) and artificial neural networks (ANN). Journal of CO2 Utilization, 83, 102773. DOI: https://doi.org/10.1016/j.jcou.2024.102773.
Farshchi, M. E., Asgharizadeh, K., Jalili, H., Nejatbakhsh, S., Azimi, B., Aghdasinia, H., & Mohammadpourfard, M. (2024). Bimetallic MOF@ CdS nanorod composite for highly efficient piezo-photocatalytic CO2 methanation under visible light. Journal of Environmental Chemical Engineering, 12(5), 113909. DOI: https://doi.org/10.1016/j.jece.2024.113909.
Heidari, M., Mousavi, S. B., Rahmani, F., Aminabhavi, T. M., & Rezakazemi, M. (2023). Insightful textural/morphological evaluation of cost-effective and highly sustainable Ca-Zr-O nanosorbent modified with the waste date kernel as a biomass pore-former for high-temperature CO2 capture. Sustainable Materials and Technologies, 38, e00778. DOI: https://doi.org/10.1016/j.susmat.2023.e00778.
Heidari, M., Mousavi, S. B., Rahmani, F., & Sene, R. A. (2024). Eco-friendly, sustainable and porous eggshell/tea waste-derived CaO nanoparticles as a high-temperature CO2 sorbent: Fabrication and textural/morphological evaluation. Journal of Industrial and Engineering Chemistry, 134, 169-180. DOI: https://doi.org/10.1016/j.jiec.2023.12.048.
Heidari, M., Tahmasebpoor, M., Antzaras, A., & Lemonidou, A. A. (2020). CO2 capture and fluidity performance of CaO-based sorbents: Effect of Zr, Al and Ce additives in tri-, bi-and mono-metallic configurations. Process  Safety and Environmental Protection, 144, 349-365. DOI: https://doi.org/10.1016/j.psep.2020.07.041.
Heidari, M., Tahmasebpoor, M., Mousavi, S. B., & Pevida, C. (2021). CO2 capture activity of a novel CaO adsorbent stabilized with (ZrO2+ Al2O3+ CeO2)-based additive under mild and realistic calcium looping conditions. Journal of CO2 Utilization, 53, 101747. DOI: https://doi.org/10.1016/j.jcou.2021.101747.
Imani, M., Tahmasebpoor, M., Sánchez-Jiménez, P.E., Valverde, J.M., & Moreno, V. (2023). A novel, green, cost-effective and fluidizable SiO2-decorated calcium-based adsorbent recovered from eggshell waste for the CO2 capture process. Separation and Purification Technology, 305, 122523. DOI: https://doi.org/10.1016/j.seppur.2022.122523.
Iranvandi, M., Tahmasebpoor, M., Azimi, B., Heidari, M., & Pevida, C. (2023). The novel SiO2-decorated highly robust waste-derived activated carbon with homogeneous fluidity for the CO2 capture process. Separation and Purification Technology, 306, 122625. DOI:  https://doi.org/10.1016/j.seppur.2022.122625.
Jin, B., Wang, R., Fu, D., Ouyang, T., Fan, Y., Zhang, H., & Liang, Z. (2023). Chemical looping CO2 capture and in-situ conversion as a promising platform for green and low-carbon industry transition: Review and perspective. Carbon Capture Science & Technology, 100169. DOI: https://doi.org/10.1016/j.ccst.2023.100169.
Liu, G., Sun, S., Sun, H., Zhang, Y., Lv, J., Wang, Y., . .. & Wu, C. (2023). Integrated CO2 capture and utilisation: A promising step contributing to carbon neutrality. Carbon Capture Science & Technology, 7, 100116. DOI: https://doi.org/10.1016/j.ccst.2023.100116.
Liu, J., Baeyens, J., Deng, Y., Tan, T., & Zhang, H. (2020). The chemical CO2 capture by carbonation-decarbonation cycles. Journal of Environmental Management, 260, 110054. DOI: https://doi.org/10.1016/j.jenvman.2019.110054.
Lotfinezhad, M., Tahmasebpoor, M., & Pevida, C. (2024a). Exploring the structural characteristics and adsorption capabilities of cost-effective N-doped activated carbon derived from waste biomass for CO2 adsorption. Environmental Research, 120017. DOI: https://doi.org/10.1016/j.envres.2024.120017.
Lotfinezhad, M., Tahmasebpoor, M., & Pevida, C. (2024b). The effect of humidity on the enhanced CO2 adsorption of amine-functionalized microporous activated carbon. Environmental Science and Pollution Research, 1-14. DOI: https://doi.org/10.1007/s11356-024-35559-x.
Manyà, J. J., González, B., Azuara, M., & Arner, G. (2018). Ultra-microporous adsorbents prepared from vine shoots-derived biochar with high CO2 uptake and CO2/N2 selectivity. Chemical Engineering Journal, 345, 631-639. DOI: https://doi.org/10.1016/j.cej.2018.01.092.
Serafin, J., Ouzzine, M., Junior, O. F. C., & Sreńscek-Nazzal, J. (2021). Preparation of low-cost activated carbons from amazonian nutshells for CO2 storage. Biomass and Bioenergy, 144, 105925. DOI: https://doi.org/10.1016/j.biombioe.2020.105925.
Shahkarami, S., Azargohar, R., Dalai, A. K., & Soltan, J. (2015). Breakthrough CO2 adsorption in bio-based activated carbons. Journal of Environmental Science, 34, 68-76. DOI: https://doi.org/10.1016/j.jes.2015.03.008.
Shakeri, N., Barzegar, B., Habibi, R., Aghdasinia, H., & Altinkaya, S. A. (2024). Enhanced performance and anti-fouling properties of polyether sulfone (PES) membranes modified with pistachio shell-derived activated carbon (PSAC)@ ZIF-8&ZIF-67 to remove dye contaminants. International Journal of Biological Macromolecules, 137654. DOI:https://doi.org/10.1016/j.ijbiomac.2024.137654
Song, C., Run, L., Liu, Q., Deng, S., Li, H., & Sun, J. (2024). Membrane-cryogenic hybrid CO2 capture—A review. Carbon Capture Science and Technology, 13, 100249. DOI: https://doi.org/10.1016/j.ccst.2024.100249.
Sun, N., Sun, C., Liu, J., Liu, H., Snape, C. E., Li, K., Wei, W.,  & Sun, Y. (2015). Surface-modified spherical activated carbon materials for pre-combustion carbon dioxide capture. RSC Advances, 5(42), 33681-33690. DOI: https://doi.org/10.1039/C5RA02665B.
Tahmasebpoor, M., Iranvandi, M., Heidari, M., Azimi, B., & Pevida, C. (2023). Development of novel waste tea-derived activated carbon promoted with SiO2 nanoparticles as highly robust and easily fluidizable sorbent for low-temperature CO2 capture. Journal of Environmental Chemical Engineering, 11(5), 110437. DOI: https://doi.org/10.1016/j.jece.2023.110437.
Toprak, A., & Kopac, T. (2017). Carbon dioxide adsorption using high surface area activated carbons from local coals modified by KOH, NaOH and ZnCl2 agents. International Journal of Chemical Reactor Engineering, 15(3), 20160042. DOI: https://doi.org/10.1515/ijcre-2016-0042.
Tuwati, A., Fan, M., Russell, A.G., Wang, J., & Dacosta, H.F. (2013). New CO2 sorbent synthesized with nanoporous TiO(OH)2 and K2CO3. Energy & Fuels 27, 7628-7636. DOI: https://doi.org/10.1021/ef401368n.
Zhang, C., Song, W., Ma, Q., Xie, L., Zhang, X., & Guo, H. (2016). Enhancement of CO2 capture on biomass-based carbon from black locust by KOH activation and ammonia modification. Energy & Fuels, 30(5), 4181-4190. DOI: https://doi.org/10.1021/acs.energyfuels.5b02764.
Zhao, J., Zhang, W., Wang, Q., Shen, D., & Wang, Z. (2024). Lignin-derived porous carbons for efficient CO2 adsorption. Carbon Capture Science & Technology, 13, 100233. DOI: https://doi.org/10.1016/j.ccst.2024.100233.
Zhou, X., Wang, D., Liu, C., Jing, G., Lv, B., & Wang, D. (2024). Enhancing CO2 capture of an aminoethylethanolamine‐based non‐aqueous absorbent by using tertiary amine as a proton‐transfer mediator: From performance to mechanism. Journal of Environmental Science, 140, 146-156. DOI: https://doi.org/10.1016/j.ccst.2024.100233.
Zhu, W., Wang, Y., Yao, F., Wang, X., Zheng, H., Ye, G., Cheng, H., Wu, J., Huang, H., & Ye, D. (2024). One-pot synthesis of N-doped petroleum coke-based microporous carbon for high-performance CO2 adsorption and supercapacitors. Journal of Environmental Science, 139, 93-104. DOI: https://doi.org/10.1016/j.jes.2023.02.008.